Pi-Box Pro 4 Case (No SD Access)

The Pi-Box Pro 4 is a rugged industrial aluminium* enclosure kit for the Raspberry Pi 4. If you need a tough enclosure for your application, look no further!

By utilising a micro-HDMI Pi4 extender board, the power and micro HDMI are located at the rear of the case alongside the Ethernet and USB connectors.

The rear panel is made from 3mm acrylic and allows for communication via Bluetooth and Wi-Fi signals from the Pi4.

A heatsink kit is included in the kit. It consists of 2 aluminium blocks which transfer the heat from the processor and RAM to the aluminium carrier plate, then out to the enclosure, making the entire assembly a heat sink. Thermal adhesive pads are included for this assembly.

This version blocks access to the SD card to stop unwanted SD removal/swapping/theft.

We also stock an alternative version which has a slot to access the SD card.

Note: Assembly required. Requires a Phillips and Torx bit/screwdriver.

Resources

• Assembly Guide

*Aluminium body with a single acrylic side panel to allow WiFi/Bluetooth signals